Skip to content
Take the quiz

Free tool · 5 min read

Body Fat Calculator, with an honest error range

A tape measure and two published formulas. You get an estimate and its True Range — because no calculator, scale or app knows your body fat to the decimal.

Updated · 4 sources · Not medical advice

Runs in your browser. Nothing is sent or saved.

Your estimate appears here, always as a range.

How the method works

The main number comes from the US Navy circumference method, built in the 1980s by comparing tape measurements with underwater weighing [1]. It uses the fact that the waist tends to grow with body fat while the neck mostly reflects frame and muscle.

  • Male formula (inches): 86.010 × log10(waist − neck) − 70.041 × log10(height) + 36.76.
  • Female formula (inches): 163.205 × log10(waist + hip − neck) − 97.684 × log10(height) − 78.387.
  • Cross-check: Relative Fat Mass (RFM) = 64 − 20 × height ÷ waist, or 76 − 20 × height ÷ waist for the female formula. It needs only two measurements and was validated against DXA in US adults [2].

Everything runs in your browser. Nothing you type is sent to us or saved.

Why you get a range, and how wide it is

Tape formulas are usually within about 3–4 percentage points of a DXA scan on average, but a single person can be off by more, and errors grow at very low and very high body fat [3][4]. So we show the estimate ± 4 points, widened to ± 5 when your numbers fall outside the range the formula was built on. RFM gets ± 4 points.

If the Navy and RFM estimates disagree by more than a few points, trust neither precisely. Re-measure, and use the overlap as your working range.

A range is not a weakness of the calculator. Any tool that shows “17.3%” without an error is hiding the same uncertainty. Read how accurate body fat estimates really are.

Measure the same way every time

  • Flexible, non-stretch tape. Level all the way around, snug but not pressing into the skin.
  • Waist: at the navel for the male formula, at the narrowest point for the female formula — after a normal breath out.
  • Neck: just below the larynx (Adam’s apple), tape angled slightly down toward the front.
  • Hip (female formula): at the widest part of the buttocks.
  • Take two readings. If they differ by more than 1 cm (about 0.4 in), take a third and use the average of the closest two.

Step-by-step photos aren’t needed: the waist measuring guide covers landmarks, timing and common errors.

What to do with the number

Use it as a baseline, not a verdict. Re-measure every 4 weeks, same time of day, same tape. If the new range overlaps the old one, the change is probably measurement noise. Your waist measurement alone is often the more useful number to track.

Questions

How accurate is the US Navy body fat formula?
On average it lands within about 3–4 percentage points of DXA, but individual errors can be larger, especially at very low or very high body fat. That is why this calculator shows a range instead of one exact number.
Why does my result differ from my smart scale?
Different methods measure different things. Scales use bioelectrical impedance, which shifts with hydration and recent meals; tape formulas use body shape. Both are estimates. Compare each method only with itself, under the same conditions.
Can I track progress with this calculator?
Yes, if you measure the same way every 4 weeks and only count changes bigger than the range. Small changes are usually inside measurement noise.
Is this a medical test?
No. It is an estimate for training decisions, not a diagnosis or medical advice.

Sources

  1. 1.Hodgdon JA, Beckett MB. Prediction of percent body fat for U.S. Navy men and women from body circumferences and height. Naval Health Research Center, Reports No. 84-11 and 84-29; 1984.
  2. 2.Woolcott OO, Bergman RN. Relative fat mass (RFM) as a new estimator of whole-body fat percentage — a cross-sectional study in American adult individuals. Sci Rep. 2018;8:10980. doi.org/10.1038/s41598-018-29362-1
  3. 3.Tinsley GM, et al. [Validation of a smartphone body-composition scan against DXA in 131 adults: mean absolute error about 3.5 percentage points; repeat-scan error about 0.5–0.7 points.] Front Med. 2024. doi.org/10.3389/fmed.2024.1485450
  4. 4.[Circumference-based body-fat equations compared with reference methods for tracking change over a short training program.] Front Physiol. 2023. doi.org/10.3389/fphys.2023.1183836

Real results, measured.

Track it over time, with the error shown

The Tensile quiz turns your tape numbers into a Tensile Index with its True Range, finds your priority zone and builds a 4-week phase around it. 3 minutes.

The quiz is free and leads to a paid, auto-renewing Tensile Membership (from $19.99/month). Cancel anytime. Estimates for training, not medical advice. 18+.